Recent content by 94STXRanger

Usually do about four compression strokes on that cylinder, so basically when the needle jumps four times, and again WOT. Its not to bad, at least none were extremely low. So hopefully no headgasket leaks.

If its an automatic, you MUST remove the driveshaft, unless you want to replace the trans.

Second on Wix

The belltechs wont give that much lift will they?

What i want to know is how you got the exact same cb as me

Man this thing is looking gorgeous. You keeping those lights?

just put a bolt in from behind?

ha alright. I broke the end of my shock bolt off. Any suggestions other than arms?

Hey you dont have a stock Ranger Rad arm do ya?

Um, I hate to be the bearer of bad news, but you may, JUST may have a toe issue. Lol man that thing looks good.

o and hope that list of nuts and bolts was close for ya

MAN if i didnt know better id say you posted the pics of my brakcets for me! Looking good man! Hope you didnt pinch your finger in your springs like i did. What are the lengths of the new coils, i still have specs laying around for the springs i got and what size they equal out to.

That light bar looks bad a##. Now i want one thanks, o and thanks for not keeping the lift! Im lovin it.still need to put the shackles on and bring the back up some though. Good luck with that pitman arm, i bent two removal tools in class before cutting it about half way down and putting on a...

Lookin good. I need to get my pics up of my lift, yeah i finally got that thing on! How much lift are you doing?

Ha in the same spot with my girlfriend^! Nice b2 though. Looking at your truck, this thing should be awesome.