Recent content by Gordy

If the lift gate is not closing tightly the 2 catches on either side (the round part in the jamb) have a torx fitting in the end which can be loosened and adjusted in or out to change how tight the lift gate latches. If that is the problem though you would think with the doors closed and the...

If the dome lights stayed on all the time it would indicate that one of the 3 buttons that trigger them is defective (one on each door and one on lift gate). By removing each, one at a time and removing the wire, it should show which switch might be bad. I believe the lighting circuit is closed...

https://www.ebay.com/itm/222992347663?itmmeta=01HR4KH06NS14X7EZCHCEZJNKZ&hash=item33eb61320f:g:zTIAAOSwoFxeRtn0&itmprp=enc%3AAQAIAAAA8IiEsfgxsPX52jFJAeuCi%2BWzKZok47KPSPJv%2FE%2FUY7a%2BYZ1PSMk1s5n26VBSobH3%2F7Stpao%2B5X409QL5An7LYw621rmk71aC5gmZaBX5omBmc2SVjZhfAtCZCU%2Fmgj5I6xpswJ0TYRwFeSOuKMLd1D...

Mine is an 85 but procedure should be about the same. Remove whatever screws you see that hold the bezel in. The knob on the light switch should have a small clip that if depressed with a small screw driver will remove the headlight switch.

I've got the same wheels and having them reconditioned and they are removing all of the Allan head rivets? bolts? or I should say they are snapping off as they try to remove them. Does anyone know if these things thread in or where replacements could be found?

Actually what I am in need of are the plastic covers that cover the latch on the 3 point belt you pull over to the short center latch

I have a working lift gate / glass handle with the rods as well if you need those.

I replaced all of my PB cables on my 85. I cussed the front cable pretty good. I ended up taking the bolts out that holds the foot lever to the kick panel area. Took a while to get it back on even though it should have been a straight forward procedure.

I had the instrument cluster out to track down an issue with dash light fuse blowing as soon as the lights were turned on. Got that squared away and when I put it back together fuel and oil pressure gauges didn't work. Took it apart again and a couple tabs on the flexible circuit board where the...

My 85 I fine tuned the idle with the idle stop set screw. I believe it was on the right side of the carb. The B2 has been at a body shop for 6 months now so it's been awhile since I've been under the hood.

Or a bad ignition switch itself possibly?

I would guess the multi prong connector to the instrument panel is the problem. I replaced my head light switch to get my dash lights working and after I had it back together the fuel and temp gauges were not working at all. Tore it apart again, disconnected the muti connector and some of the...

Sounds like the throw out bearing on the clutch is bad. Noisy when disengaged and when pedal is depressed and pressure is put on the bearing it quiets down.

Check E Bay. Lots of options...

When I purchased my B2 last year one of the issues was that the previous owner had backed in to something and the spare tire / carrier cracked the fiberglass lift gate. I got a good used lift gate and the B2 is at the body shop now to have the gate painted and installed. I tore the rear apart on...