•  

    Click HERE to join our forum and participate in the discussions.

     

Recent content by Murhpi


  1. M

    2.9L exhaust mating surface

    what material is the mating surface for the exhaust headers? Cast Iron like the block or aluminum?
  2. M

    89 B2 FM145 Trans fill plug

    I pulled the trans to replace the clutch and while prepping noticed that the fill plug was all sorts of mangled. It appears someone went at it with a pair of vise grips. I drained it and got the trans out, but after looking at it in daylight, realized that there is just no way that this bolt is...
  3. M

    89 B2 suspension refresh

    I found a good deal on Gabriel Ultra shocks that were purchased for a 90 Ranger, then never used. I can not find whether or not they will be a direct swap for my Bronc2. Anyone know if the part numbers G63524 and G63614 will fit the 89 B2?
  4. M

    Radio/cigar lighter wiring

    Just got my 89 b2 and the dash illumination lights dont work (no big) but i pulled out the cluster, found some burnt out bulbs which may be the culprit. During my investigation I found a blue wire with an orange or red stripe, it appears to go to both the cigar lighter and up to the stereo area...
  5. M

    My Bronco II before any work

    Done nothing but install a new rear drive line, and fluid change and bleed.

Top