Search results

Has anyone seen a website that might show/share some of the stock graphics of 2nd gen BII's ? Also how about a tri-colored BII stripe??

I have a'89 BII, that caught FIRE, a couple months ago, I put a new fueltank and pump, lines and wiring. Now when she runs gas comes out the muffler, and she ran like CRAP...Could the FP Regulator be bad or clogged or stuck open..Or do I have bigger problems...

Haven't been on this site in a while,So I will get straight to my Question,On my way home from tech college,my 1989 Bronco II started sputtering and then backfiring, car behind me started blowing their horn,So I looked out my drivers window and flames were coming out between my tire and...

Any idea why ford put TWO catalytic converters on 1989 BII? Got two BII's and they both have two..Gonna try to cut one set off, haven't had a muffler on her in years..And are ALL stock exhaust support to be 2.25", Think about trying to put a Red Hot Muffler afterwards..THE O2 Sensor is before...

I hope I can pull my 2.9L out off my BII.I tried to flush out the oilpump screen w/o pulling the pan,now she seems to be locked-up.Gona try to pull engine and flush out the screen.Any ideas of the best solvent to clean her with, remember she sat for 7 yrs and looks like crude from Quake State...

What is the easiest way to remove gunk from an oilpan? this BII sat up for 7 yrs. I am thinking about Easy-Off to remove the dried oil from my oilpan.Also soak the pan in gas for a day or two.Spray the crank and inside with Easy-Off to looosen up the Old Quaker State. ANY IDEAS Will be...

Was I the only one that noticed a BII in the latest episode of NCSI/LA? It was in the background when the agents went to a commune to find a witness to a murder. So COOL...

Can I just take the distributor cap and rotor off when I lift up the motor to drop the oil pan? I read that I need to d/c the intake tube,remove the fan shoud,d/c the exhaust manifols from the exhaust and take the motor mounts loose. I don't want to pull the whole distributor, the shaft inside...

How hard is it to put dual exhaust on BII with a dummy case? Does it help with gas mileage and performance? Is it worth the MONEY?

Why would someone time a BII 2.9 off by one cylinder? I tried to time starting at 1, but she wouldn't start. No power to pull off, but starts, do I need to pull the distributor and begin with No. 1 and advance until I get to 12 degrees TDC? Also valves are knocking. Just a driveway(shade tree)...

didn't ya'll have a tech tip on getting rid of dummy case on 2wd BII'S and putting a one piece from a ranger. I thought I might get a couple more MPG if I do this.Also it should make the BII about 75-100 lbs lighter.

Anybody have any luck cleaning the screen by simply dropping the oil pan and either removing the screen or blowing it out with air. I am working on 1989 BII by my self with no helper and no friends to assist me. Got a half-brother but he likes to be paid in natural light, and just adds to the...

I bought a '89 BII that was sitting for 6+ years, Dropped gas tank,new tank & fuel pump, cleaned out fuel filter. Drove to Wally World I could hear valves sticking. Pulled off valve covers, spent 3+ days scrapping CRUD off the heads, another day cutting off valve cover gaskets(rubber w/...

Is the switch suppose to be up or pushed to be reset. I just bought 1989 BII with 85,000 miles the owner parked.He said It just quit running so he bought a Chevy. He had replace the fuel-pump, she will turn over and run a few secs on starter fluid. I will remove the fuel filter and see if she is...

I swore ya'll had an article about eliminating the dummy case on a BII, I want to get rid of the D-case and put headers, thrust mufflers and better air filters to help with gas mileage and performance, HELP!!!! P.S. This is the 6th time I have tried to contact Ya'll.