Search results

Hi all , I have two water pump bolts that are forced, can we tap bigger and what diameter?

I am not lucky enough to live in the USA, here in Belgium it is very difficult to find parts for a Bronco2, it was never sold by Ford, only a few independent importers imported it so there are no don't have many

Hello, are the front fenders of an explorer 1 compatible with the bronco2?

ah i got it i will try tomorrow

sorry but my english is limited, what is the cranks

Thank you for your answer Uncle Gump, what is the best adjustment of the advance? 10 degrees BTDC or 12?

Hello, I have a problem with my B2, when I stop the engine after driving a little, I don't know how to restart right away, the engine acts as if the battery is flat, but it's new so it's not that, I'm thinking more of too much compression or something like that, which would decrease over time...

that's what i thought, if anyone has a 1988 owner's manual in pdf i would like it. Thanks again for the replies Best regard Henri

Hi all , as in the title, is there a fuel warning light in the dashboard of a 1988 Bronco II ? , I don't have a manual so I don't know how to check best regard Henri

Hi guys, i'm trying to adjust the linkage on my 1988 Bronco II, mechanical linkage not wired, i'm adjusting it in three as shown in the Chilton book and when i try to move the gearshift, i won't not far away in the park and first, a tip or a tutorial that would be perfect?

Hi guys , I am thinking of rebuilding my a4ld gearbox, has someone already done it and would have advice to give? A kit to recommend ? or is it better not to try. I will have with me an old tractor repair mechanician who is a very meticulous guy

Thanks for the answer, my problem is to know if it's bad for the gearbox, otherwise I don't mind waiting 2-3 minutes before starting, because afterwards, it has the strength as before

if I could I would put a manual gearbox but we don't find one here in Europe, unless try a European gearbox but I'm not sure we could adapt it

No, it's just a reflection I don't see what could delay the deposit, if the level is not correct directly, something is not opening or slowly and I do not see anything else than the solenoid, but I'm ready for other suggestions

Ok but that does not explain why it does not start immediately, I was thinking of a solenoid which would open too slowly since it takes a certain time before the level drops at start up

difficult to explain, when cold, I change all gears for 5 seconds and the level is too high, after 2-3 minutes the level is good and the gearbox reacts, I tried by adding 1 pint of oil more , it's worse, then I took out 2 pint and it reacts faster on startup but the level indicates too low (or...

Hello, I will try to explain my problem to you. I start the engine and I put the lever on R or D of my A4LD gearbox, there I feel a good engagement as if it was normal and then nothing for about 1-2 minutes the Bronco does not want to move, after this time it starts to move forward or backward...

Hi , i'm from Belgium , i have a 1988 Bronco II , here in Europe we have difficult to have parts for USA cars . I have search up many dealers (rockauto , ... ) but i dont find the part i need . Someone can give me the Motorchraft number from the transfert switch like this picture ?