•  

    Click HERE to join our forum and participate in the discussions.

     

Search results


  1. jmcfates

    FM145 Rebuild

    Hey all, I am on working rebuilding the FM145 transmission in my 85 BII and I accidentally bought the rebuild kit for the FM146. I know the FM146 is longer but have heard the internals are pretty much the same. My question is can I use the FM146 Rebuild kit I ordered to rebuild the FM145 or do I...
  2. jmcfates

    ECM Questions

    I am swapping the 4.0 from a 95 explorer with an automatic transmission into my 85 bronco II with a manual transmission. I plan on replacing the entire wiring harness but am not sure what issues may result from using and ECU tuned for an automatic transmission in a manual transmission...
  3. jmcfates

    4.0 Swap: Runs dies and VSS Wiring

    Awesome thank you for the info.
  4. jmcfates

    4.0 Swap: Runs dies and VSS Wiring

    So the stock fuel sender will work with a brand new pump?
  5. jmcfates

    4.0 Swap: Runs dies and VSS Wiring

    Hey, I know this is an old post, but I am doing a 4.0 swap into my '85 Bronco II from a '95 explorer. Can I just swap the fuel pump over or am I better off buying a new one? If buying is better, what recommendations would you have on a good reliable fuel pump?
  6. jmcfates

    85 Bronco II 4.0 swap from 95 explorer

    As said above my donor is a 95 explorer. I plan on also using the 8.8 rear end out of the donor as well. My question is does anyone know if the Dana 35 from a 95 explorer is a viable replacement for the Dana 28 in the Bronco?
  7. jmcfates

    Could I swap an '06 explorer V6 into an '85 Bronco II

    I appreciate the reply. That is what I needed to know. I was hoping they were the same block but I didn't know for sure.
  8. jmcfates

    Could I swap an '06 explorer V6 into an '85 Bronco II

    Hey all I have an '85 Bronco II XLS. I know you can swap a V6 from an early 90's explorer but does anyone know what issues I would run into with swapping in a V6 and transmission from an '06 explorer? I am mostly concerned with how much if any fabrication (of mounts and such) I will need to do...

Top