Hi Jerry, good morning and thank you sooooo much for this information. I had Firestone start the alignment process yesterday and what a challenge this is. My plan now is to remove the old spring, with the new donut, and install the 1 1/2 to 2-inch lift springs, from Bronco Graveyard. Plus the adjustable camber/caster nuts. That's $199.00. Of course, the camber/caster can only help to a maximum of + or - 2.75 degrees and mien are higher. Hence, Thank you, it is great to hear about the "adjustable radius arm bushings ". Which is very good news for me. I also have been shopping for new shocks front and rear. Do you have an opinion on the brand of shocks? I've been looking at several of the top brands, thus far and haven't made a choice yet. This Dana front end is bringing a new and frustrating challenge to me. I've done a ton of work thus far and I still have more repairs and upgrades on my grocery list for my little Bronco. It's a fun ar to drive and it deserves to be brought back to a great Bronco II example. It was made in the Kentucky plant and has been a California car since day one. Thus, no rust. The last owner just drove it and didn't spend any money on maintenance, etc. The good news is they only had it for about a year...Thanks again for the help.