Gizzaf
New member
- Joined
- Jun 4, 2013
- Messages
- 21
- Reaction score
- 0
- Points
- 0
- Location
- Colorado Springs CO.
- Vehicle Year
- 1987
- Vehicle
- Bronco II xlt
- Engine Size
- 2.9l
- My credo
- If it wasn't for the last minute, nothing would get done!!
i put an 88 2.9l into 87 and followed it with engine harness & EEC. I can't remember where the connector plugs into it the 2 wires coming out of the sensor are back and a white one where does this plug into please help. using an 88 harness and up front where the power distribution box is at on an 88 well on a 87 they use fuse able links. there are these two connectors by the battery. they each have 3 pins coming out i don't see any thing they go to. is it possible they were for something else or an option i don't have with the 87 and for some reason i don't have low oil sending unit on this engine 88 or 89 no were so what do i do about that wire? also right by the starter on the block there is a 2 pin unit on the side of the block what's that for and what plugs into that? i hope someone with a good electrical knowledge can help me out i need to get back to driving every day for work since I'm 21 years in the air force and going strong . I'm really reaching out for some guidance
V|R,MSgt. MJ
V|R,MSgt. MJ