abrush
New member
- Joined
- Oct 30, 2007
- Messages
- 40
- Reaction score
- 0
- Points
- 0
- Location
- Nebraska
- Vehicle Year
- 1988
- Vehicle
- Ford
Alright, I am gaining ground. I got all my guages, headlights, wipers, etc. to work on my 1988 bronco II currently undergoing the 4.0 swap. :
It turns out that I didn't have the ignition wire hooked up so I had no power to my ignition, lights, etc.
After I figured this out I could have celebrated thinking that I would for surely get the thing started tonight but obviously it's not my night. This is my dilema:
I have spliced the pink 14 guage wire on the Explorer harness into the red/blue wire on my B2 harness that runs to the ignition. I have then hooked that wire on to my solenoid where it should be. I have checked my grounds and can't see where I missed any. I also used my test light to see if the wire got hot when I turned the key over but it did not. Did I do this right or am I missing something to get it to start? I am so close!!!!
It turns out that I didn't have the ignition wire hooked up so I had no power to my ignition, lights, etc.
After I figured this out I could have celebrated thinking that I would for surely get the thing started tonight but obviously it's not my night. This is my dilema:
I have spliced the pink 14 guage wire on the Explorer harness into the red/blue wire on my B2 harness that runs to the ignition. I have then hooked that wire on to my solenoid where it should be. I have checked my grounds and can't see where I missed any. I also used my test light to see if the wire got hot when I turned the key over but it did not. Did I do this right or am I missing something to get it to start? I am so close!!!!