Recent content by 77ford

I've got an 89 Bronco II with explorer running gear. I took it to SMORR this weekend and broke the driver side radius arm (lower connection to the 35). Lucky for me it rolled the front end and popped the drive shaft so I found it pretty quick and was able to limp it back to the trailer. My...

The BRII was a manual but the running gear and computer where both automatic. I think the computer and transmission should be he same. However, I doubt they hooked up the wires for the neutral safety switch. I'm going to look for them this weekend. I think it's running too rich, I was hoping...

Hate to bump my own thread but I still cannot figure this out. I can't find anything on the web about this issue. Could it be because of the not in neutral? I'll see if I can track those wires down and fool the computer to think it's in neutral for the test.

I've got an 89 bronco II with the 4.0 motor swap in it. I decided to check the codes on it today, the key on engine off test ran fine. I got a couple of non issue codes, not in neutral and purge canister solenoid failure. However when I try and do the running codes the code reader will not do...