Recent content by AKBroncoII

Push the female end onto the line first before trying to pull them apart. Push together with the tool in place >< Then pull apart <>

Happens right at 65 and over. Very annoying. Just swapped tires so I know it's not the tires. Redid the rear driveshaft ujoints in December. Wheelbearings, balljoints and all steering is tight. Happens in 4th gear and 5th gear. Vibration doesn't change when clutch is pushed in. Caster is...

I ran the early style crossmember on my 86 and had no issues. Cleared the cats just fine.

The stock explorer fuel filter will snap right onto the factory BII plastic line. Same style line, just different type of release. I made a very short adapter line on my 86 BII. Pretty much hub/hub with the two straight factory plastic barbed ends. Go easy with a razor knife and you can...

I took all the lines from the 4.0 back to the filter. I moved the factory bronco II filter back in the frame, this allowed me to install the fuel lines to the engine crossmember on the driver side frame rails just like the 4.0 lines were factory. I had to make some short lines with fuel...

Yes it will work, I have seen this from the factory. Rear seats even had power lumbar.

I won't see him probably at all this year. The closest I will be to you would be Vancouver on the 1st of may. But I have no idea where I'll be staying yet.

You can't ship flat rate postal? I did to you.

Joel, are the headlights centered in the openings? It's hard to tell %100 from the pics. Mine ARE and I need some trim pieces. How did you attach them? I was contemplating making some from fiberglass or aluminum.

I don't think the 88's had EGR anyways. I thought it was an 86-87 only thing.

Depending on how wide you want, some Limiteds and XLT's came with flares from the factory.

Man, that thing looks a little rough. Hopefully it was close to free.

What do you mean by offset?

Last I checked rear RBV springs are 56"s long. Not much of an upgrade to go with 53'' spring.

Then you don't have something hooked up right elsewhere. Those two wires need to be hooked into the pink/black wire in the explorer harness. Are you getting key on power to the two red/ltblue wires? I wouldn't even bother worrying about what is or isn't working right now. Get EVERYTHING...