Major progress on my Bronco II project. I took the entire drive train out of a 1998 explorer and put it in the Bronco. Including the 4 wheel ABS and cruise control. It had a 2.9l V6 with a four speed trans. Now it had a 4.0l V6 with a five speed automatic, 3:73, 31 spline, 8.8 rear axle with...
Phase 2 of the cowl repair. I fiber-glassed the small holes and then applied brush-on seam sealer. Once that cured, I used a self leveling seam sealer for inside the cowl. I jacked up the passenger side of the Bronco so that the seam sealer would flow along the inside cowl seam. It was messy but...
Hey folks, I've had only one other B2 but I've had a few Rangers. This one is an 89 that I'm swapping a 4.0/trans/transfer case/rear axle from a 98 Explorer. When I put the dana 35 from a 94 explorer, I'll have 4 wheel ABS and the electronic cruise control vs vacuum.
But I digress, I've started...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.