Recent content by SR185

ROFLMAO:icon_rofl:

Thanks. I'll order a new switch.

My dash lights and overhead light are very dim (on my '84 BII), even when the headlight knob is turned to maximum. Turning the knob will turn them on or off, but they will not brighten. I replaced all the bulbs with new LED's and the problem is the same. Is this a problem with the...

The original rubber radius arm bushings on the BII are shot. I'm looking to replace with poly bushings, but have a couple of questions: 1. Are kits like this http://broncograveyard.com/bronco/i-93004-radius-arm-bushings-84-90-red.html for only one side or both sides? 2. I noticed that some...

Fiberglass scrap?

$25 will cover my cost. I'm not trying to make anything for it.

I bought a BII cargo cover today from a local salvage yard. I do not need it, but picked it up so see if any of you all wanted one. This cargo cover is gray and has all the brackets and hooks. I'll sell it for $25 shipped if anyone wants it. If not, I'll put it on Ebay.

I got the lower cushions out of the Bronco II. But, how do you remove the center bracket for the upper cushions? EDIT: I figured it out

Yes, you have to have a wire running from the coil to the center pole on the dizzy

Looks good! What lift do you have? And I bought a set of the same wheels, but I don't have the center caps. What center caps are those?

I sent you a PM. I think I can help.

You want to keep both sides of that 8-wire plug. The side leading towards the passenger compartment contains wires going to temp sensor, oil pressure, and alternator - you don't want to cut. Look at the picture in post #15 of this thread...

Did your AAL give you 3" in the rear? Were your springs sagging prior to the lift? How does it ride now compared to before?

I just purchased both pigtails from NAPA a few weeks ago. I gave them the order numbers listed on the DS instructions, and had them a few days later.

Did anyone else have to bend their automatic transmission dip stick tube, so they could have enough clearance for turning the distributor?