Search results

are you guys putting the front fender skins back on?

nice! What unit bearings is he using up front?

When you gonna sell the ranger?

Let me know when you do decide to make the trip down

When you gonna bring that beast down to Harlan or Ivy Branch and play on the big rocks?

lmao. Hows the booger? I miss seeing pics of that truck

So rear is pretty much done then? Are you going to put a doubler in this?

DRW front D60 is the same as the SRW front D60, they just added spacers for offset.

http://www.pirate4x4.com/forum/dodge/653085-dodge-dana-60-front-tech.html Edit: Went through the thread and picked out some info. From what I see, 94-99, 00-01.5, and 01.5-02 were all different. 70.5" WMS to WMS on the single wheel. Edit again: 01.5-02 are the only non-cad. 00-02 all run...

Cool man. Thanks for the info. Pretty sure 94-02 all 3500 trucks were duallies. The 94-02 trucks did have dana 60s in them in the 2500 trucks though. 03 is when they changed the body style and went to the Common Rail. The 03-05 trucks you could get a 3500 single wheel.

did you swap the hubs over to single wheel? Do they have lockouts or is it a unit bearing setup like the ja-heeps. so the axles spin, but the transfer case is not engaged?

Where did you get the front axle from? I thought all Dodges after 94 had the disconnect

Whoa.

yep. Same reasoning I use!

that's awesome man

What are you going to use now? Rod ends at both ends?

Was that just a normal poly bushing on one end, rod end on the other type deal?

well... I guess both!

ahahaha. oh ok. have you found out what the culprit was?

A mattress on your porch and a flat tire?