Just measured my 94 Limited Ex. it was 40 3/4" inches .....so yeah I would go with 41".... mine was in a wreck a long time ago so who knows if my frame has been tweaked a little:icon_confused:
On the driver's side interior door panel there is a switch that has 3 buttons. It is a seat memory switch that you can set 2 different seat adjustments for different size drivers.
It is located right above the power mirrors control switch. Oh and you need the wiring harness for it. I don't know...
Do you have your add a leaf under your overload leaf spring?
I think you are going to have to move your add a leaf up one more in your spring pack. That is why you can't get the u-bolts tight.
Do that and see if you can get your u-bolts tight.
Do you have a C-clamp? you can clamp (compress)...
I say go for it. A friend of mine put a ranger cab on a B2 frame but built a mini steel flatbed. He was in the works installing a 5.0 in it but he never finished the project.
I think the chop box looks better.
Looks like a fun project you have there. Where did you buy the lift kit from?
I am looking for a cheap lift for my 94 4door ex.
I would leave the rear swaybar off, but if you want it back on I think you will have to get longer links or there might be some drop brackets for it.
I think why...
Damn sorry about your Bronco 2, glad to hear that no one was hurt to bad.
I was surprised that those hose clamps held up.
Did it roll more than once or was it a flop on the side then on the roof?
I guess you can join the roll over posse now:icon_rofl:
Well what ever your plans are I am sure...
Hey 1989 Bii be careful with those hose clamps and with a load on that rack.
If you have to do a hard stop or fast manuaver to avoid hitting some one or something those hose clamps probably will snap and then who knows where the rack could end up at........not good.
I think you can find...
Looks good :icon_thumby: can we get some more specs on that homemade rack?
Is it made from conduit? How is it bolted to the explorer racks?
So how are the goodyears treating you? I am still thinking about getting a set.
For the cost of putting a TTB 44 in I would just go fullwidth solid dana 44 and 9 inch rear but thats just me. Looks like you are going to have a fun project anyways.:icon_thumby:
Nice pictures, looks like the Duratracs throws some mud.
So how do you like those Duratracs in the mud?
I am still looking for a new set for my 94 Explorer and next time find some deep stuff to see what that Bronco can do :headbang:
Yeah I had to replace mine a few years ago.
On the ECM there should be a label on it with a code and numbers. You have to match that code from a junkyard one. My 94' Explorer had two different ones that came from factory and go figure the one that was in mine was one that was hard for the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.