Search results

Need some input - trying to decide if I should shorten my front bumper to only the sides of the frame rails. Basically to where the new lower plate is on my bumper. I really wont know completely how it will look until I get the bumper remounted with the winch and roller fair head. Need some input

picked up a extended flex rear drive shaft. It is not a Carden type. My current drive shaft is a carden custom job. It is starting to spread at the rear axle so it needs work. any thoughts on running the NON -Carden Drive shaft? I know that I will have to change the angle of the rear axle from...

Decided to just start a thread to track my progress Traded a Polaris quad for this bronco. It was smash9002 bronco his build -http://www.therangerstation.com/forums/showthread.php?t=8368 list of things done to it. updated 10/25/2010 body 1989 cut off hatch custom square tube bumpers 4"...

found a 4 speed tranny with manual transfer case in a 86 bronco II in local junkyard. Guy told me it was his and swapped in 4 speed as was sick of 5 speed breaking. would this be better than my mitsi 5 speed electronic transfer case that I have now? my goal is to go crawling on rubicon this...

well the bronco does not have a sway bar on it right now and really needs one. what options from ford do I have? what explorer and ranger ones will fit? right now I do not even have the brackets so I have to go to the junkyard and pick all of it.

well i brought smash9002's bronco home. Guy sold it cheap to me as it is not running very well. he replaced MAS sensor, crank sensor, TPS, EGR purge solenoid, Intake Air Temp, cleaned IAT - I took IAT off and verified it was cleaned and worked correctly now it runs fine when cold when it is...