Search results

so yesterday, i was being stupid, on a backwoods gravel road. i as doing clutch dumps at 5 grand and getting the truck sideways well i lost control. along side the road was a little dirt berm about two feet tall, i spun out and hit the perm side ways mostly with my right front tire. jumped over...

so as i was riding around in my buddys '96 eb explorer i realized that i really like his front bucket seats, and was wondering if they would bolt in to my '87 eb b2. i found a CLEAN set at the local junk yard for $125.00, i just dont want to spend the money if they wont bolt up. has anyone done...

on my '87 eb b2 is the display panel in the center console, in the upper left hand corner of the panel is a little black button that sticks up about half an inch. my questions is, does anyone know what this button is suppose to do?:icon_confused:since ive gotten the truck i cant figure out what...

can anyone tell me where the resistor pack for a '87 eb b2 is?

ive been bouncing a few ideas around for the 2.9l and my gf brought up the idea of tt t3s, the only problem i could foresee is the engine management. other then internal engine what does everyone think of this?

ive been bouncing a few ideas around for the 2.9l and my gf brought up the idea of tt t3s, the only problem i could foresee is the engine management. other then internal engine what does everyone think of this?

at about 45mph my roof on my b2 pops, when i slow down it pops back, is there any way to stop this?

so in the quest for more power i am converting my internal regulated alternator(87 b2)to a external regulated alternator. so i went down to the junk yard and grabbed a alternator and the voltage regulator and on the voltage regulator there is four wires or/lt bl, wht/blk, yel, and lt gn/red. and...

so yesterday i head out to get my sister and i noticed my '86 2.9l b2 running a little rough, so this morning i go out and pull the codes off of the computer and i got code #89,86,95. the only problem is that my truck is not an auto tranny!! so i pull the kick panel off and take down the...

ok so i ordered a 4" lift kit from skyjacker and getting ready to install it in the next few weeks, i know the rear drive shaft needs changed out and im wonder if ford made anything that would bolt up in there, im also wondering if the front or rear pinion angles has to be changed for this lift...