The OP described the plugs as dark and oily
. If the HG was bad . one of the plugs would have been steam cleaned. Borrow a compression tester and read up on how to use it. Condensation in the exhaust will steam for quite a bit. Generally speaking if the...
No experience with this situation but, can you use a round file to elongate the bolt holes a bit to move the cover to center? If I figured right , you want to move the cover to the left. Then use Aviation Forma gasket to help seal the cover to the block.
How did the interview go? My son's college car was an ugly 86 BMW. It started out with a peeled clearcoat and then was totaled twice. I had a buddy put it on his frame jack and pull out the worst of the rear end hit. Then I cut and pasted stuff with JY parts. Didnt...
Turn up the radio. I know I'm a big help. This problem will get louder if it is the exhaust. If it is the torque converter or the flex plate, you will know when the truck wont move. :D
My Ranger came to me with out a shift motor. Just a rats nest of wires . Too cheap to buy a shiftster, so I used a pair of 5'' vise grips to shift it into 4 w high. When I want 4wd, I lock in the manual hubs . I keep the vise grips in the side pocket of the door.
Drilling and using 3/8 bolts and some 3/16 flat stock or angle depending on the problem your fixing. I dont have a welder, but I have had good luck with bolts keeping my Jeeps together. You have a rig that you know. Bash it straight and fish plate it. :icon_thumby:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.