"Project BARB" 1986 bronco 2
93 ranger danger donor I picked up for 800
4.0l dash and engine swap
Dana 35 w/3.73 swap
Ford 8.8 w/3.73lsd swap
Let's see if I can get it done
Also anyone that reads this, my 2.9 has manifold gasket leaks on both sides and leaks some oil outta most of the gaskets. But it's developed an issue of bogg'n itself down with gas most time it comes back to an idle. You can hear it especially with the exhaust leaks but it starts choking itself...
10/16/15 Update
It been awhile but...
I've been busy working away on this OBS RBV POS 1986 Bronco 2.
This past May my fm146 blew up again after 3 prior doctors appointments at the local transmission shop. I had done enough reading online and eventually early august i ended up buying a 1993...
I blew up another clutch plate but it hasn't gone out just yet but im starting to get some ugly noises from my clutch/trans. I've got the 2.9L with the 4 speed with overdrive. My plans for the future build is to swap the 4.0L in. But i'm going to need a transmission here in the next month and i...
I've done some research about what i should do about swapping in axles because my bronco has the stock axles with open diffs front and rear. What i've concluded that i want to do is take the larger axles out of a 91-93 explorer that has at least a limited slip rear diff. I am definitely...
Lake Michigan dumped more than a foot of snow on us in less than a day... so my buddy and i took the trails. 98 XJ with a 4.5 inch Zone lift on 31x10.5 Wrangler Duratrac's. 86 Bronco 2 with a 3 inch James Duff Stage 1 lift on 31x10.5 General Grabber AT2's. I'm so impressed with how well the...
I got the Light Bar off of Amazon for 130 bucks, but before buying such a surprisingly cheap Light Bar i read all of the product reviews to see what others have to say about it. Turns out a few of the reviews say it wasn't waterproof. A few of them said they waterproofed it themselves, so i took...
I went on slyvania.com and found the part number for the bulb in the turn signal. After i got that i typed that number into Amazon and found LED bulbs for not too much. It was about 30 bucks for all of the lights except for the reverse lights. Also electrical load resisters are needed for the...
got a bronco2 center console from the junkyard and put a switch panel in for my light bar and other accessories. Mounted the 40" bar on the hood and it doesn't look too bad
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.