Search results

Got it andThanks again. they sure buried he ETC but I going to try to get to it today.

Update: Found an IDM in the good old salvage yard and also changed the IAT. After warming it up it ran fine. Still have the cold start problem where it takes at least 3 tries to get it running then the rpm surges going from roughly 500rpm to 1000rpm for a few minutes until it starts warming up...

here’s the latest. I started over fresh this morning and still have the same cold start issues it it ran good after warming up as usual. I retried reading the fault codes KOEO and got a code 18 in the continues codes. this is the same code I can not get rid of. In the definition section of the...

Where is the IDM located on a1987 bronco Ii. UDATE : I found the IDM and now need to find one or a replacement resistor to replace it. I still get a continues code 18 when checking KOEO. While searching the code definitions in the continues codes it says states causes could be the following, (...