The plug is in the harness about six inches back from that multi pin plug in the trans and it's on about a six inch pigtail. As far as not getting any gear I think I didn't pull the inner shift rod all the way out by hand before I put the nut in the kickdown linkage arm
I pulled the transmission to replace the main seal and the filter and when I was putting it back together I wound up with two two pin connectors that I don't know where they go and the transmission will not shift into any gear. Any help would be greatly appreciated.
I have an 86 Ford bronco 2 that I blew the transmission main seal in so I pulled the tranny replaced the filter and the seal and now I have two two pin plugs that I don't know where they go and the transmission will not go into gear.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.