Recent content by bfiakas

On my 88 B2 the 3rd fan speed setting stop working today and what is strange is that the 2nd speed was blowing harder than usual this morning and then later today the 3rd setting stop working.Could it be the fan switch or the resistor that would cause just one fan speed to stop working?

Has anybody upgrade to a 92 Explorer(group 65) battery on a B2? Oreillys has Motorcraft which have the smallest dementions and have 750 CA and 750 CCA capacity.I was concerned if the starter could handle the higher amps.

I am looking to tow a pop up trailer this summer with my B2.The factory bumper towing capacity I beleve is 2000 lbs.and my GVWR is 4200lbs. So when figuring what I could tow do I include the cargo weight(750 lbs) and the trailer weight (1700 lbs) or would 2000 lbs be max load overall?

I ordered a set of 2 degree camber bushings and I am 1 degree negitive on camber.When I install the new bushings to get close to spec.What reference do I use( outside or inside) of the balljoint stud.

What are the advanages of installing a 180 deg. t-stat in my 88 Bronco 2? Will my gas mileage suffer due to the engine running cooler?

I am going to install a new 2 core radiator in my B2.Has anybody that has done this had any overcooling or computer problems.

I am running a 1 deg.negitive on camber and want to replace the old factory camber bushings with adjustables.O'Reillys Auto Parts.has many in stock at differant measurements of degs.like 1/4 to 1-3/4 degs.What do I have to know to get the right brushings.

Does anybody know what the maximum weight the swing out tire carrier will handle? I want to mount a black 48"x 24" cargo box on it to store my camping gear.

Have you tried a Ford dealer parts dept. that will take the time to investigate other cross reference parts .Or find a bolt company that will make a complete set for you.Also you can make your own by buying bolts longer than you need,like a 6 inch bolt with short theads.Cut them off and re cut...

Have you installed a back flush kit in the heater hose to flush out the block? 192 deg. is stock for the T-stat.Install a new water pump and radiator cap and hoses (Gates reenforced type)

I figure I would cut out from the top center of the deck and then cut a oversize patch from a doner B2.Thanks Adsm08 for the help.

Then roughly 2 inches down from the top of the deck for the cross cut?

Anybody know the measurments for cutting a hatchway in the rear cargo deck to replace the in tank fuel pump.

2 1/2 cans plus 1 can of oil 4 0z. if you evacuated the system.

Generaly with low fuel pressure the return line should be clear.If you suspect the fpr to be failing and when you replace it, then you can check the return line.Have you done the TFI plug voltage checks? One other queston,have you changed out the stock radio/sterio with a aftermarket? If you...