Hello, I'm doing a 4.0L clutch swap in my 90 Bronco II.
I already know I need to match to the same year slave and master cylinder hose because the ends are slightly different. Out of all the slave cylinders for Explorers the 93+ are the only ones I can find with a boot/dust cover.
Since the body...
Hey guys, so I've not seen any 4.0 swap threads that explain what to do after swapping a Ranger harness then correcting the brake light/power window issues. *Please link a thread if there is a full write up*
Anyway, that issue has lead me to investigate alternative methods of doing the 4.0...
I'm wondering if I can swap my 90 BII dash with a older model dash. I like how the old dash allows for quick heater core replacement. It took me about 10 minutes to put a new heater core in my 88 Ranger. :D
A guy on Craigslist has a 87 Ranger with about 3.5" suspension lift so I'm wondering if the kit will fit my 90 BII ? I know the 87 Ranger should have a Dana 28 but my 90 BII has a D35. Just wondering if the drop bracket and all will interchange.
I had to bump this old thread simply because it deserves the attention.
Anyway, He said the A/C Compressor interferes with the power steering gear box. I would assume relocating the compressor would fix that problem.
To begin with I know my roof seams are busted and caused my roof liner to get wet. I started taking all the interior out and found some new areas of interest. Both kick panels are currently wet. The back of the computer was starting to rust. I also noticed some foam inserts in the both kick...
You want to get a first generation Explorer front driveshaft.
Remove the factory double cardon joint from that shaft and get some new u-joint flanges or remove 2 slip yoke portions from the rear d-shaft of the Explorer to obtain flanges.
Do a "Search" for Explorer driveshaft modification.
ttt
O.K, so let me re-phrase this since no one seems to know the answer.
How many splines are one the 2nd Gen Explorer (95-96) front driveshaft ?
And how many splines are on the 1st Gen Explorer driveshaft ?
I just bought a 90 BII.
I had the same problem. I pulled the plugs and discovered which injector was bad. #4 was the problem on mine.
Runs like a champ now.
I recommend running some fuel additive to clean that cylinder/piston rings and valves. I bought a large bottle of Lucas for $12 at...
I'm reasearching the Explorer front driveshaft modification (u-joint) for my 1990 Bronco II.
I need to know if the "Front" Driveshaft Slips are interchangeable from 1st Gen to 2nd Gen.
I keep finding several guys with the earlier models BIIs that have no problems switching the entire front...
One more thing, I guess the fuel pressure regulator could have some part to do with it too. You can test your fuel pressure. I just don't know how to do it. LOL :)
Good luck
I'm not a mechanic but I'm thinking fuel pressure. Maybe when you turn into a parking spot your stirring up the fuel and sediment/rust causing fuel pressure to drop. The idle could also be caused by this (I guess). Say you have a weak fuel pump , trash in the tank and clogged fuel filters ,... I...
Anytime you raise or lower a vehicle it affects the steering and the way your tires wear.
I'm not sure if a 2 inch suspension lift requires additional modifications such as longer tie rods or not.
Someone else will have to answer that. If not, just take it to a alignment shop and they will...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.