I have a Bronco 2.9 that is in a complete rebuild process. It has had a little head and intake work done to it just for the heck of it and now I'd like to find cam with just a little performance biult in to in it to take advantage of the work put in the rest of the motor. Plan is just to put it...
I've had leaks start at the rain gutter above the door due to cracked / missing seam sealer. Water ran down the corner post to the kick panel and into the floor.
The degree to which it is clogged is the question. I pulled a pump off a 2.3 that a hammer and chisel would have had to been used to remove the buildup. No solvent would have had much effect. And this was my vehicle that had the oil changed every 3 to 5 thousand miles. It did however, have...
I'd go with option A. That line should be available at most parts stores. However, I would change it to a copper line. It will hold up much better. You will most likely need to change the connectors if you use copper.
Option B will stop the leak but disable the oil cauge in the truck. I'll...
It sounds like it could be a line going to a direct read oil pressure gauge. Does the vehicle have an aftermarket oil pressure gauge in it?
Is hose about an eighth of an inch in diameter?
The pivot bracket for the passenger side beam has to be switched. It is the one attached to the crossmember under the motor. It's not a bad job when there is no motor in the way but not much fun from underneath. It is riveted in places and requires a bit of grinder work. I switched a BII from...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.