Search results

check your timing, to advanced can make it hard to crank when hot. If you dont have a light, just try changing it when its cranking hard.

I have done 4 durasparks with cardone dizzys, and i have had trouble with all of them. I have had to sand the end of the shaft that runs the oil pump and on others the aluminum casting that sits inside the block.

I have a 84 bronco 2 that i started doing the duraspark conversion on and i got everything in and it will start and run but i cant get get it to idle i am using a 2150 carb with the 1.08 venturis but it is off a bigger engine. It will run good at hight rpms but it just dies at lower revs unless...