Search results

Ebay user name : 1ford1988 Suspension: Never Installed 4” Rough Country Suspension Lift- NEW IN BOXES with UPGRADED SHOCKS! NEW EVERYTHING! New coil springs, leaf springs, all hardware, nitrogen charged shocks, and brackets, ready to install! I paid $750. - $500 Rear Diff. Axle Cover/Guard-...

Hey guys, I had purchased a used 1967 6-bolt 289 V-8 from to swap into a BII, but the project has been put on hold for at least 5 years. I was told that it had been rebuilt once, but not recently. It did run, as the guy showed me it running on an engine stand. It appears to be a 100% complete...

Hey guys, I have located this for my 1988 Ford Bronco II when I planned on doing a stock restoration on the vehicle, but changed my mind after finding out how rare this set was. It has basically just been sitting in my home to prevent rust or aging of any kind, and I consider it to be a rare...

Dropped my 88 bronco II 4x4, 5-speed, 2.9 V-6 off at the shop due to an oil leak. I purchased a new oil pan gasket, and a timing gasket set including the front crankshaft seal, timing cover seal and water pump seal. With that being said, the garage charges $75 an hour for labor. They said I am...

Dropped my 88 bronco II 4x4, 5-speed, 2.9 V-6 off at the shop due to an oil leak. I purchased a new oil pan gasket, and a timing gasket set including the front crankshaft seal, timing cover seal and water pump seal. With that being said, the garage charges $75 an hour for labor. They said I am...

So, on my 88 bronco II, my rear hatch will shut, but only the pass. side latches...i cant get both sides to latch shut...i even replaced all of the door strikers and it still wont line up....any ideas? anyone else have this problem?

Anyone else have any problems installing pacesetter headers? I installed a set of the ceramic coated headers on my 88 bronco II 4x4, 2.9...on the drivers side the header came in contact with the fuel filter sheild thingy...To get it installed, i had to put a spacer between the motor and the...

So, my "tulip style" driveshaft needs to go....and im looking for a good new driveshaft with u-joints that will work with 4" of lift on a 88 bronco II 4x4 5-speed....any advice? I was thinking maybe the one from bronco graveyard. Also, im prolly gonna replace the front driveshaft too, any advice...

very excited, just bought a 4" rough country suspension lift with the rear lift leaf springs for my 88 bronco II. Im debating on installing it myself or letting a garage install it for me. What did you guys do? I am also going to be replacing all the bushings with poly ones, removing my body...

anyone know where i can get a front mount receiver for my 88 bronco II? I plan on using a removable multi-mount winch. I have had no luck finding one....help?