Well i have the same pressure while crusing 2-3k rpms as the 10w30 but know i have roughly 10psi at idel compared to less than 3 before. Engine doesn't act any different than before doesn't tick never did it before though.
Yah i would love to have any psi at idel.
Already have a mechanical gauge. And have no lift tick, so i just have huge holes in the block allow little pressure to build then.
It drop like a rock once warm and idling but, get the rpms to 1.5 and ive got 12psi. In the mornings i get 40psi. This is with the 10w40. Could the pump be going?
Well see i dont leak a drop nor do i burn any. It either the passages have been painted which i highly doubt. My oil pump sucks, i highly doubt, or my gauge is f*****d. On cold start my oil is 40-45psi but after a 13 mile drive its down to what i said.
Cant ask the rebuilder since it was done 4 years ago but ive only put 10000 miles on her. Also the rebuilder went out of business for apparent reasons. Shity work
It may be 7-10 psi its hard to tell. Some time it sits at almost 0 while in drive siting at a light.
84 2.8 b2
Once I've driven for a few minutes my oil pressure drops to like 5-7 psi while Idling
The engine was rebuilt a less than 10,000 miles ago and has been like this since I got it...
Is this a problem, I don't think the rebuilder did a true rebuild.
Sent from my iPad using Tapatalk
If their is no ecm im assuming your 5.0 is carbed...
Only mordern ecm take control over almost all functions in the truck, there are also independent gem and sjb that control body function
Sent from my iPhone using Tapatalk - now Free
mine did this even when my engine was warmed up along time ago, my mechanic disconnected something and now it idles high on start till i tap the gas and it never idles high again until it cools down on the next start up.
Check your under dash wiring harness for lose grounds, and wires shorting out, or you can start pulling fuses till it goes out to identify which circuit is providing it power to stay on all the time. It could just be a bad switch.
Ive had both on the back of since people like rear ending me so much, right now i have the solid sealed glass and i hate it compared to the other two i have had with the opening window. How hard is it to do the swap. I have the old glass and interior latch components.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.