I have an 87 Bll 4.0 that keeps having issues with the temp/fuel gauges reading ok one minute and the next pegged out high. Years ago I remember seeing where someone made one rather than buy more that never seem to work longer than 6 months. Anyone have any info on where to get one that will...
I found out that the diameter of the spindle is 1.624 from the threads to the step for the seal. The ID of the bearing collar is 1.625. I remeasured mine and they're a little smaller than spec and I can't seem to find any spindles so I'm going to get some new bearings and put it back together...
I looked in my factory manual I have hoping for some specs but couldn't find any. I have a pretty good set of slide calipers so I measured the id of the bearing and the od of the spindle and came up with .006 difference. Would that be enough to hold that collar and not let it spin?
Thanks for...
How much wear is allowable on the spindles where the bearing collars ride? I was taught that if you can catch a finger nail on them that's to much. Thoughts? Thank you
Ok I have an 87 Bll 4.0 with factory cluster and I want to install a cluster out of a 84 Bll 2.8 I know that I'll have to change senders, oil/water, from light to gauge What else? Thank you in advance.
Have an 87 Bll non factory air that's got a heater fan issue. Thought it was the fan switch because when driving home fan just quit but when I moved the heater/fresh air door switch it started working again. So I bought a switch that came with an a/c button on it like my 84 with add on air has...
I bought a project from a guy who started the 4.0 swap. The motor is in as well as the 93 Explorer harness.It will turn over by the key but won't get the fuel pumps to turn on and the relay doesn't click like my 89 Bronco ll. I don't have power at the PCA on terminal 1 yellow wire which needs...
I've got a 84 Bll 2.8 tk5 Ive done the duraspark conversion put on a set of rebuild heads and had the trans completly done by a specialty shop I lost the bottom end 0 compression in a couple holes not valve train related Just wondering if there may be any interest for any parts I'm in N Idaho
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.