2.8 engine photo

[jonnygorman]

guys, i am looking for a picture of a 2.8 l engine. I am assembling mine after along time apart and can't seem to figure out where the bolt goes to fasten the the dipstick tube to the engine. It has to either be a bolt that goes into the block or that holds some smog tube deal into the rear of the exhaust manifold. Anything that can give me an idea would be great. I think this bronco has finally driven me crazy.

Thanks
Jon

 

[5.0B2]

No picture, but I'm pretty sure it goes on an exhaust manifold bolt that also holds the heat riser. It will be a bolt with a threaded section above the head.

 

[Bronco_Chuck]

i can check tomarrow. and ill try to remember to get back on here and post a picture. But sorry if i dont.

 

[jonnygorman]

Tease!

If you could post a pic it would be awesome.

Thanks
Jon

 

[Ruffinit]

I'll get you one tonight if it's not too dark when I get home.

 

[Bronco_Chuck]

well my computer is kinda ****ed up right now and i dont have the soft wear on it to get the pic from the camera but ill look for the disk, i can say that the bolt goes into the block right behind the driver side exhaust manafold ill post a pic with in 30 mins

 

[Bronco_Chuck]

sorry about the quality there off my phone.

Hope this helps.

 

[Totalled]

It bolts to the side of the block by the bellhousing.

 

[Ruffinit]

Hmmm.. Shoot, I thought you were talking about the tranny dipstick, so I got a great pic.... Just not what you wanted and it looks like you got it covered anyway. :icon_thumby:

 

[crazy horse]

If its anything like the 2.9, I believe it mounts on the exhaust manifold.