86 bronco 2 will not go into any gear

[taj]

I pulled the transmission to replace the main seal and the filter and when I was putting it back together I wound up with two two pin connectors that I don't know where they go and the transmission will not shift into any gear. Any help would be greatly appreciated.

 

[taj]

Also has an aod trans.....

 

[tw205]

Reverse lights, safety switch and converter lockup should be down there. It’s been a while since I’ve been under mine. Check drivers side above and next to the shift lever.

 

[taj]

The plug is in the harness about six inches back from that multi pin plug in the trans and it's on about a six inch pigtail. As far as not getting any gear I think I didn't pull the inner shift rod all the way out by hand before I put the nut in the kickdown linkage arm