foss40z
New member
- Joined
- Apr 3, 2008
- Messages
- 7
- Reaction score
- 0
- Points
- 0
- Location
- SoCal
- Vehicle Year
- 1988
- Vehicle
- Ford
- Engine Size
- 2.9 Liter
I just picked up a 94 tranny from a ranger truck to swap in my 88 bronco 2 that had a 87 tranny in it from another swap. it had a 88 a4ld in it with 3 wires. that tranny went bad so i had some hole in the wall mexican shop find 1 and put it in and he put in an older 2 wire 87 tranny. the truck was originally 3 wire. i spliced the wires back together and took it for a drive and it goes threw 1st,2nd and 3rd just fine. but overdrive wont work. its like it dosnt even have od. is there a wire not spliced right? solenoid bad?, something i am missing?
also i noticed reverse is hard to get it. there is only a little area where it will go in. is my floor shifter not right for this tranny? should be the same though because it is a a4ld.
any info i would greatly appreciate
Mr.Foss
also i noticed reverse is hard to get it. there is only a little area where it will go in. is my floor shifter not right for this tranny? should be the same though because it is a a4ld.
any info i would greatly appreciate
Mr.Foss
Last edited: