90 B2 tranny output adapter

[dooleyross]

Looking for the adapter from the tranny output to the driveshaft flange. Any available or know a source to get one?

 

[ab_slack]

I assuming you are looking for output shaft to the square four bolt flange?

On the B2 \the tranny output always go into a transfer case? A dummy case for 2WD drive vehicles, so it would be the transfer case output with the drive shaft flange.

I guess for Rangers they had a configuration without a transfer case, but I don't know if they ever used the flange type drive shaft.

 

[dooleyross]

from what I found, on 90 BII's, they used a different 2wd transmission and stopped using the dummy transfer case. They used instead an adapter that slides over the output shaft and connects to the flange/yoke.

 

[dooleyross]

http://www.broncoiicorral.com/library/facts.shtml

read at the bottom

 

[ab_slack]

That is probably a rare bird then. I wonder if 2WD rangers used the same configuration.