Dustquake
New member
- Joined
- Aug 7, 2015
- Messages
- 2
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1986
- Vehicle
- Ford
I've got a dealer installed A/C. Never worked while I've had it because the line to the condenser ran over the compressor pulley and was chewed through. As I need to retro anyways, I want to install all new.
I've identified the compressor as an SD-508, I think, but I am unable to find parts that fit this setup. I can purchase all the parts for the factory system, but I am unable to find anything to give me placement, mounting, etc. As the Sanden compressor only has one electrical lead, I would need to figure out wiring, and get the compressor mounts to attach the hoses.
I'm hoping for identification of this setup so I can go with what was there, or images/descriptions for the factory A/C such as where the expansion valve and accumulator/dryer fit in.
Just registered, and hopefully I got the picture posted properly, This is my entire current A/C system as was under the hood
I've identified the compressor as an SD-508, I think, but I am unable to find parts that fit this setup. I can purchase all the parts for the factory system, but I am unable to find anything to give me placement, mounting, etc. As the Sanden compressor only has one electrical lead, I would need to figure out wiring, and get the compressor mounts to attach the hoses.
I'm hoping for identification of this setup so I can go with what was there, or images/descriptions for the factory A/C such as where the expansion valve and accumulator/dryer fit in.
Just registered, and hopefully I got the picture posted properly, This is my entire current A/C system as was under the hood
Last edited: