Is there anything else that tells the parking brake light to come on? Other than the plastic spring sensor on the parking brake pedal?? For some reason my light is always on, I tried un-plugging and replacing and light is still always on?? Any info
I got an 8.8 out of an Explorer for my 89 bronco ii. I'm in the process of welding in the spring pads as well is finding the pinion angle. I'm running explorer leaf springs and 3" blocks. I have the axle hanging with drive shalf on. Right now the blocks are not welded. The angle of the...
Looking for some lift shackes for my bronco. I'm running a Ford 8.8 Rear now, and I dont want to keep my lift blocks. The blocks I have are 3", so what size shackes would I need? And were could I fine them? Still running the stock left spring with a add a leaf. At some point will upgrade...
Grounds are all good. cleaned or replaced with new yesterday. Grinded all the paint and dirt away. So I would say the grounds are good. All look into checking the ignition switch.
thanks
Found what you were talking about. There are two of them on my b2. I got a new ground cable, and clean and tested everything, and still not start. Maybe a broken tooth on the timing chain, will have to check still.
Ok all check grounds today after work. And think about looking at the timming chain. I was trying to rule everything esle out before taking the front end apart to get to the timming chain...haha Looking for the easy fix button...
If it was the timming chain, I should not have spark, right Beacause the distributor would not be turning?? Right?? Also I would have heard the engine get really ruff before it shut down if it was the the timming chain, but I could be wrong?
Have an 89 bronco ii. Was running fine, drove all day. Started and stop it. Was driving home and pull over to side of road for a min. Bronco was idleing and then die. It sounded like it ran out of gas. Trying to re start and will not start. Has plenty of gas. Got it home and checked fuel...
Hey just got my b2 back together again. I rebuild the motor and everything is new on her. I have put about a 150 miles on the rebuild now, and I went for a longer drive yesterday, and I was going up a hill and the motor started to knock. It only knocks going up hills, flat fine, freeway fine...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.