I just pulled the positive cable off battery while engine was running. Thanks for advice I will use a volt meter and see what the volts are. I will let you know what I found.
The volt gage drops below 12v and the headlights dim when I come to a stop but the volts go back to normal when I start driving. I checked the alternator its good and my battery is good. Any ideas whats going on? Thanks
That's what I was thinking, I hope that will fix it, and along with the new plug wires I did put in a new rotor cap and button, I'll check those too thanks.
My B2 engine sputtered a couple times while driving through rain, it has new plugs and wires do you think I need to put some silicon seal inside the plug wire boots? Thought I'd ask before I get in to it.
I hooked wires directly from the battery to blower motor and it spun so blower motor is good. Also noticed the 30 amp fuse under dash was burnt and broken, I replaced that fuse and the AC compressor turns on but fan speed still not working on all speeds. I hooked a circuit tester to the wiring...
My Blower motor stopped working today I cranked the bronco then pushed the AC button on and turned the blower on high. Blower motor hesitated then stopped working plus the blue AC light stopped working. I checked all my fuses they are good. Is it the blower resistor?
My 87 B2 front wheels making a squeak noise once every full rotation. Its not worn brake rotors. Squeak only happens when pulling into a parking spot or leaving my driveway or parking spot does not squeak while driving down road. Could it be the bearings? Only had the B2 for a year but then...
Today I hooked wires from the battery directly to the motor and nothing but a clicking sound I guess its time for a new motor probably get both drivers and passenger side motors. At least the AC runs good lol.
https://www.summitracing.com/parts/rnb-90627/overview/ The metal part that goes inside the door look on this looks flat. That's why I need to know if the hole is square or flat. Shine a flashlight inside the hole on the door let me know.
I have a 1987 B2 for about a week I've noticed the windows don't go down unless I've been driving a few miles. Now the drivers window wont move at all, I cleaned the window up and down switch contacts that didn't work, also notice when I push window button up or down I hear a click sound from...
Whoever put in that distributor put it in 1 degree off, the number one pole on dist cap is in the number 4 position. Shes running now Thanks for helping me on this and take care.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.