i found a 2010 ranger axle

[heptofite]

How hard will it be to make it fit my bronco II?

 

[Original_Ranger84]

It should bolt right up, but it won't have L/S and it will have a vss on it I believe

 

[alaskan155]

same as an explorer axle, you have to re weld the axle perches other wise your springs will do this \ / ranger and BII axle aren't the same,and yours is an 86 Bii so no rabs so the rear vs s sensor doesn't matter, will just make a place for you to fill it with fluid.

some people have forced ranger axles into bII but its not recommended

 

[heptofite]

i thought ranger axles and b2 axles were identical, they look the same between my ranger and my b2...

 

[heptofite]

i just read the axles page, and the ranger axle is 3/8ths of an inch wider than my bronco axle, isn't that close enough?

 

[4x4junkie]

Ranger axles are about 2 inches narrower at the leaf perches.

 

[heptofite]

Ranger axles are about 2 inches narrower at the leaf perches.

yeah but are you sure the 2010 axle is?

 

[Sasquatch_Ryda]

Yes, the frames and mounting points have not changed.

 

[heptofite]

well damn.

 

[fordwheelinman]

It should bolt right up, but it won't have L/S and it will have a vss on it I believe

how can you be so sure its not a l/s?

 

[Jspafford]

how can you be so sure its not a l/s?

I am pretty sure they did away with the LS option and replaced it with a traction control that is supposed to make up for it.

 

[Sasquatch_Ryda]

Yes they did. No more l/s option just traction control.

 

[Original_Ranger84]

Yep They switched over to traction control... because its SOOOOOO much better.

Well actually it is for people that only use it on the road.