shawn.m
New member
- Joined
- Feb 11, 2010
- Messages
- 166
- Reaction score
- 0
- Points
- 0
- Location
- 18 miles se of placerville,ca
- Vehicle Year
- 1989
- Vehicle
- Ford
- Engine Size
- 4.0
picked up a extended flex rear drive shaft. It is not a Carden type.
My current drive shaft is a carden custom job. It is starting to spread at the rear axle so it needs work.
any thoughts on running the NON -Carden Drive shaft? I know that I will have to change the angle of the rear axle from the current 8 degrees up to about 2 degrees up.
My current drive shaft is a carden custom job. It is starting to spread at the rear axle so it needs work.
any thoughts on running the NON -Carden Drive shaft? I know that I will have to change the angle of the rear axle from the current 8 degrees up to about 2 degrees up.