Recent content by Roger

Bringing this thread back from the dead. I recently found a 84 B2 without engine and trans, owner was planning a V8 swap and ran out of patience... Last summe, my son and I stripped the 90 Ranger and installed EVERYTHING from his 94 Explorer. Fun truck, and does get a little better MPG than...

You might give some thought to using a 97 Ranger D35 setup so you get better brakes. I'm considering a B2 project and IF I keep the TTB it will be a 97 setup specifically for those brakes.

GO to www.theretrofitsource.com for as much info as you can handle for HID retro fitting. I intend to do a swap into my 95 Grand Cherokee as soon as I can scrape the $300 bones together...

Sounds like a plan! Sorry about the thread jack.

Nope, looking for an early B2 with dead motor or trans. So I can swap the 2.3 and 5 speed into. Overall plan is not a speed demon, or a monster wheeler. Just a fun cruiser. Thanks for the info on the crossmember, nice to know my fabbed 2.3 mounts would drop in. As mentioned, we took the...

Since I'm considering doing the same thing, I like the idea. We yanked the running 2.3 and 5 speed from our 90 Ranger a couple weeks ago, so we could transplant an Explorer 40 and A4LD in instead. More power. But now I am looking for an early B2 for the 2.3. Is it a bit less power? Sure...

Me too...

I have a 90 Ranger with 2.3 and 5 speed. Its likely going to be swapped out for a Explorer 4.0 and A4LD. Has anyone put a 2.3 in a B2? I don't need it as a trail monster, or a speed demon. Looking to chop the top and make it a nice weather cruiser.

Might fab something like this if I keep the TTB... But I also don't like heim joints in single shear.

I like it...

Done. Not real hard. Just different than what I'm used to is all. Plenty of synthetic grease for the slides. Next time I'll replace the slides though. Well, off to the local racetrack for the Teraflex All Jeep show... Rocks and ramps and vendors yippee!!!

I don't have it apart yet, but 94 Explorer 4x4. Wanted to have an idea what I was getting into before I dig in in the morning...

Neither here or at Explorer forum. I need to replace the brake pads on my 94 Explorer and I can't find a thread showing how to work with the slide pins. I've done lots of other brakes but never these... Pics very helpful...

Which takes the place of your roof...

Doors only provide structure when hit in the sides. Otherwise the latches and hinges would be a LOT more robust. I've covered a lot of accidents and doors aren't that much structure. And there isn't that much extra reinforcement in the door frames of Wranglers. That aside, I see a good...