Search results

ok so this is what i have. Was wheeling today engine was running awesome. hit some high revs and it died. no pop no bang just shut down. have spark have fuel did a compression test and got weird readings. did test on cylinder 4 and 5 and four times each. readings were weird 60, 60,40,75. did a...

Just throwing this out there but I have had lifter tick and oil pressure light flashes under 2000 rpm for 2 years now and she still runs strong (2.9L) I don't know if I would worry about it just for a fishing rig

agree check pcv valve (Positive Crank Case Ventilation Valve)

or im running 5:13's with 37x14.50 15's

And i instead of iba...

i meant wires not outters. Sorry auto correct once my phone blows.

When iba didnt mine i just got the floor platewhere the shifter comes through the linkage to mount the t-case shifter the tranny the peddal rod and the clutch peddle. i didnt mess with the computer i justo had to wireing the reverse lights switch to the existing reverse sensor wires. U only use...

i would only go an inch its so close.

oh ya engine cross member is all custom to... kinda got a little plass happy haha:icon_welder: had to redo the hole thing which turned out best for my track bar mount. so i have a few pics but not all cant find them all right now if there are anything u want to look at specificly let me know i...

ok guys sorry been away for awhile but im back and the rig is done! rear dana 44 out of a scout 2 and a dana 44 out of an early bronco. both are stuffed with 5:13 gears and are locked. rear carrier is just welded the front is i believe a spartan locker. i did the chevy/ford disk brake conversion...

locker*

ok cool thanks:icon_thumby: ill probably just have my drive lines lengthened then and my rear flange changed to a yoke type. so update i finished my rear dana 44 axle finally all set up with locket and gears new brakes and bearings. just got 40 feet of 1 3/4 .120 wall tube for sliders 10 feet 2...

It has a slip yoke so its a 1350 anyone know if i can get a slip yoke with a bigger u joint on the end?

I think I have a 1354 manual case ill check in a bit when I go out to finish building my rear axle.

Hey guys sorry I have been out of the loop for awhile but I got the front eb axle complete. I am running 5.13s with a spartan locker 3/4 ton axle shafts and the chevy disk brake conversion. I did the dana 50 ttb yoke upgrade this where I have a question. What are people running for drive lines...

i got mine out of a ranger that had a double cardinal u joint on the one end which means it has two u joints on one end and the other end down by my rear axle is just a normal u joint. i just had a local shop cut it down and re balance it for i think $65. ill try to get some pics today and show...

ok so this is what i got. i was at moyie springs mud bogs this last weekend and i was doing the creek crawl and messing around when i noticed my dummy oil light flash a couple times then shut off i stopped checked my oil it was fine. then the next day was driving around it came off and on and no...

Hey guys so im getting everything together to do a sas swap but this is the issue i have. i traided some stuff for an eb d44 well come to find out i got #$@%ed and i got a rusty housing inside and out. i wanted to get everything together to rebuild it but i just found a complete ready to bolt in...

oh thats cool. ya like i said i would have loved to go to a m50d but i had the other one so i decided to just do that.