zachv91
New member
- Joined
- Aug 1, 2013
- Messages
- 1
- Reaction score
- 0
- Points
- 0
- Location
- Fort Hood, TX
- Vehicle Year
- 1987
- Vehicle
- Ford
I decided that I wanted to remove my doors and put quick release pins so I can get almost a Wrangler type set up more or less. I did some research on it and just couldn't really find much. So I'm posting this so maybe the next guy doesn't have to look so hard. The biggest worry for me was the door power wiring harness. I'd prefer to just have no power at all but I just don't feel like dropping the cash for new doors. The wires run from the door all the way under the front fender to right behind the head lights. Its connected with a simple harness. Just undo this and you will be good to go. There should be some clips running along the wire underneath the fender securing it to the body of the truck, but this wasn't so in my case. I simply pulled the wires right out. Way too easy. But if you do run in to some clips, honestly a solid tug will most likely break the crappy plastic clips and it will come right out. From there I just cut the factory door hinges and replaced them with a quick release pin so its just a matter of seconds to remove my doors and put them back on. I way over estimated this job. It was super easy and I'm very happy with it. So hopefully this helps somebody who was thinking just a little to much just like I was.