Yes, they will fit. When you take the seats out of the BII, take the seat off the seat frame. They just unbolt. Do the same with the Ranger seats and bolt them back on. What you'll have is the new seats bolted onto the BII seat frames and all will work well.
That is.. I'm assuming that you are going from bucket to bucket or bench to bench.
I put 93 Explorer seats onto my 86 BII seat frames. The passenger side seat hinge had a smaller hole that needed drilling out, but everything else was bolt-on. I put the BII seats onto the Explorer frames and installed them into my 61 Falcon. The high back seats looked bad in the Falcon.
Has anyone used the replacement tracks from BroncoGraveyard.com? One of my seat tracks is rusted to hell. Thinking about ordering a new set of tracks and then finding some new seats too. Just wondering if they are worth the money.
ok sounds like these seats might not work then there from a 97 exploder and there fully power adjustable soo they probly wont flip forward i didnt really think of that part thanks guys
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.