seat swap

[kaytor692]

i found a set of seats from a 93+ ranger wanted not no if they will fit in my 86 b2?

 

[Ruffinit]

Yes, they will fit. When you take the seats out of the BII, take the seat off the seat frame. They just unbolt. Do the same with the Ranger seats and bolt them back on. What you'll have is the new seats bolted onto the BII seat frames and all will work well.

That is.. I'm assuming that you are going from bucket to bucket or bench to bench.

 

[kaytor692]

sweet ya im going bucket to bucket but the driver seat from the ranger has a console attached there 60/40 split combo

 

[adsm08]

60/40 splits are considered buckets.

 

[sjr53]

I put 93 Explorer seats onto my 86 BII seat frames. The passenger side seat hinge had a smaller hole that needed drilling out, but everything else was bolt-on. I put the BII seats onto the Explorer frames and installed them into my 61 Falcon. The high back seats looked bad in the Falcon.

 

[kaytor692]

anyone no if mustang seats will fit (out of a fox body)?

 

[forzda]

anyone no if mustang seats will fit (out of a fox body)?

yes they will , but you need to change the seat rails

 

[kaytor692]

will 97 exploder seats fit on my 86 B2 rails? they are power adjustable if that makes a difference

 

[MrE_Powers]

only the seat rails from a 91 sport will fit b 2 if i recall correctly.

 

[kaytor692]

will the seats themselves fit in the B2 rails and sliders?

 

[MrE_Powers]

yes... i have 94 ranger seats in my 84 with the 84 rails.

 

[inuyasha2875]

two door explorer seats are nice and i used the expo seat rails in my 86 bii so now both front seat flip forward and slide all the way up to the dash

 

[SmokeEater829]

Has anyone used the replacement tracks from BroncoGraveyard.com? One of my seat tracks is rusted to hell. Thinking about ordering a new set of tracks and then finding some new seats too. Just wondering if they are worth the money.

 

[kaytor692]

ok sounds like these seats might not work then there from a 97 exploder and there fully power adjustable soo they probly wont flip forward i didnt really think of that part thanks guys