Bronco Bob...
I dont have Bronco wiring to look at anymore either. However, The wire thats spliced in is going to the multiple fusible links in your harness. Just a place to start when you find a schematic.
Yup,
That is a pretty old pic of CopyKats rig, its now painted and such. Pretty sharp looking rig! However, I think its missing its headlight bezels :D
Actually, Joel and I did the headlights a bit different. While he used Ford buckets and had to do some hammerology... I used Dodge D100 buckets that were all self contained. They just needed to be screwed on. His round lights were behind the bezel, while mine stick through more like stock...
63" Chevy's into B2... The Progress Continues
I am just starting on my 63" swap. I got a set of Teraflex lift shackles, and 5.5" lift ProComp 63" springs. My goal was to lose the old Skyjacker springs and blocks and gain a bit of flex. I already pulled the overload and angle shim out of the...
I run a 79 F150 D44 High Pinion up front. Its full width with radius arms and there are a ton of aftermarket goodies for this axle! The rear... well we wont talk about that right now :bawling:
As for the coilovers.... SKIP THE FOA's!!!! You get what you pay for, get the Fox or King's. I have...
AZ, I love the MTR's. I have run the BFG AT and Mud previously and the MTR's are hands down better in every category. My only complaint with them would be is that they dont make them any bigger than a 35 in a 15" wheel. For 37's and up, you gotta switch to 17's. But then again, BFG has done the...
Yup...custom grill. :icon_thumby: In my area, its pretty rare to see a non-stock Bronco II. So besides the other mods, this was just another way to set it apart from the rest.
I cut up a stock grill and glued in handmade fiberglass bezels made by Copykat! :icon_thumby:
The buckets are out of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.